Recovery Guide Boot This loader supports updating via the RS232 port, even if broken bootloader.

1. Make sure that the receiver is disconnected from the power supply (via the switch on the rear panel) and connected to a computer via an RS232 port.

2. Download the boot loader and the latest software Link nur für registrierte und freigeschaltete Mitglieder sichtbar.

3. Unpack the archive UARTLOADER.zip at any place

4. Change the name of the software on rom.bin and place the file in the unzipped folder UARTLOADER, where file ConsoleDown v1.3.3.11.exe

5. Opening the file with notepad ConsoleDown.bat you will see the default settings - "ConsoleDown_v1.3.3.11.exe-f. \ Rom.bin-c 3-i 1512-b 115200 \ n pause".

You need to change the "-c 3" which is the number of COM ports in your system. Set the desired number of the COM port. The default is No. 3.

6. After confirming the settings, save the file. Then run the modified file ConsoleDown.bat.

When properly configured, the window will look like this:

Link nur für registrierte und freigeschaltete Mitglieder sichtbar.

7. Turn on the receiver. Screen should look like this:

Link nur für registrierte und freigeschaltete Mitglieder sichtbar.

9. If, within 10 seconds, nothing changes then restart your receiver.

10. If a successful connection will transfer the data and write flash memory in the receiver. With a successful recording, the program will display the following:

Link nur für registrierte und freigeschaltete Mitglieder sichtbar.

11. Restart the receiver after the successful completion of the procedure of firmware.

12. When an error occurs, press ctrl + c to stop the program and restart the procedure.

greetz xkallex