Code:
[ 3.913000] ------------[ cut here ]------------[ 3.913000] WARNING: at /home/newnigma2/build/snapshot/oe2.5/build/dm520/tmp- glibc/work-shared/dm520/kernel-source/kernel/smp.c:464 smp_call_function_many+0x 118/0x398()
[ 3.913000] Modules linked in:
[ 3.913000] Call Trace:
[ 3.913000] [<805cff24>] dump_stack+0x8/0x34
[ 3.913000] [<8002340c>] warn_slowpath_common+0x78/0xa4
[ 3.913000] [<800234bc>] warn_slowpath_null+0x18/0x24
[ 3.913000] [<80077258>] smp_call_function_many+0x118/0x398
[ 3.913000] [<800774fc>] smp_call_function+0x24/0x34
[ 3.913000] [<80309bb4>] brcm_machine_restart+0x10/0x44
[ 3.913000] [<805d00e4>] panic+0x194/0x20c
[ 3.913000] [<805cff1c>] dump_stack+0x0/0x34
[ 3.913000]
[ 3.913000] ---[ end trace 667767be765fd473 ]---
Dreambox DM520
M0CZS
L2=1
LLMB=1
BrCfg=E30FB7C6
#@
BCM973625A0 CFE v15.3, Endian Mode: Little
Build Date: Fri Aug 19 11:48:16 2016 (Jann@Cynric)
Copyright (C) Broadcom Corporation.
CI box detected
card if inited
Enabling NAND flash at CS2: A5U4GA31ATS(DEVICE ID=0xC8DC9095), ECC Level=4, Spar e Area Size=16
MACRONIX SPI flash detected: Size = 16MB, Sector Size 4096, Page Size 256
CPU speed: 751MHz
DDR Frequency: 1061 MHz
DDR Mode: DDR3
Total memory(MEMC 0): 512MB
MEMC 0 DDR Width: 16
Boot Device: SPI
Total flash: 16MB
RTS VERSION: rts_hevc10_1067
ETH0_PHY: INT
ETH0_MDIO_MODE: 1
ETH0_SPEED: 100
ETH0_PHYADDR: 1
DM init finalization
yxml: processing file of 131072 bytes... succeeded!
no file loaded, create xml restoring default xml
loaded network params of: DHCP, 192.168.0.219, 255.255.255.0, 192.168.0.1
[1] type 3, dev nandflash0.kernel, loader elf, filesys raw, file , options
[2] type 3, dev flash0.kernel, loader elf, filesys raw, file , options
[3] type 1, dev eth0, loader elf, filesys tftp, file , options bmem=192M@64M con sole=ttyS0,1000000 root=/dev/nfs ip=dhcp
added 3 sources to autoboot list
init fp
Initializing USB.
CFE initialized.
found card in unknown state
ca valid!
***** DREAMBOX SSBL *****
Not interrupted yet, trying autoboot or rescue loader, hit any key in the next 5 00ms to cancel
Proceeding with autoboot.. You can try aborting with Ctrl+C
*** Autoboot: Trying device 'nandflash0.kernel' file (raw,elf)
Ethernet Cable unplugged
Loader:elf Filesys:raw Dev:nandflash0.kernel File: Options:
Loading: 0x80001000/7588032 0x8073d8c0/235952 Entry address is 0x805cd1d0
Closing network eth0
Starting program at 0x805cd1d0
▒[ 0.232000] console [ttyS0] enabled, bootconsole disabled
[ 0.232000] console [ttyS0] enabled, bootconsole disabled
[ 0.236000] loop: module loaded
[ 0.237000] brcmstb_nand: NAND controller driver is loaded
[ 0.238000] tun: Universal TUN/TAP device driver, 1.6
[ 0.239000] tun: (C) 1999-2004 Max Krasnyansky <maxk@qualcomm.com>
[ 0.361000] bcmgenet: configuring instance #0 for internal PHY
[ 0.381000] bcmgenet bcmgenet.0: (unregistered net_device): link down
[ 0.382000] ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
[ 0.383000] ehci-brcm ehci-brcm.0: Broadcom STB EHCI
[ 0.383000] ehci-brcm ehci-brcm.0: new USB bus registered, assigned bus numbe r 1
[ 0.415000] ehci-brcm ehci-brcm.0: irq 66, io mem 0x10480300
[ 0.421000] ehci-brcm ehci-brcm.0: USB 0.0 started, EHCI 1.00
[ 0.422000] hub 1-0:1.0: USB hub found
[ 0.422000] hub 1-0:1.0: 2 ports detected
[ 0.423000] ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
[ 0.424000] ohci-brcm ohci-brcm.0: Broadcom STB OHCI
[ 0.424000] ohci-brcm ohci-brcm.0: new USB bus registered, assigned bus numbe r 2
[ 0.425000] ohci-brcm ohci-brcm.0: irq 67, io mem 0x10480400
[ 0.491000] hub 2-0:1.0: USB hub found
[ 0.491000] hub 2-0:1.0: 2 ports detected
[ 0.492000] Initializing USB Mass Storage driver...
[ 0.493000] usbcore: registered new interface driver usb-storage
[ 0.494000] USB Mass Storage support registered.
[ 0.494000] i2c /dev entries driver
[ 0.495000] lirc_dev: IR Remote Control driver registered, major 253
[ 0.495000] usbcore: registered new interface driver btusb
[ 0.497000] TCP: cubic registered
[ 0.497000] NET: Registered protocol family 10
[ 0.499000] NET: Registered protocol family 17
[ 0.499000] Bluetooth: RFCOMM TTY layer initialized
[ 0.500000] Bluetooth: RFCOMM socket layer initialized
[ 0.501000] Bluetooth: RFCOMM ver 1.11
[ 0.501000] Bluetooth: BNEP (Ethernet Emulation) ver 1.3
[ 0.502000] Bluetooth: BNEP filters: protocol multicast
[ 0.502000] Bluetooth: HIDP (Human Interface Emulation) ver 1.2
[ 0.503000] L2TP core driver, V2.0
[ 0.503000] Registering the dns_resolver key type
[ 0.504000] PM: CP0 COUNT/COMPARE frequency does not depend on divisor
[ 0.506000] EBI CS2: setting up NAND flash (primary)
[ 0.507000] NAND device: Manufacturer ID: 0xc8, Chip ID: 0xdc (Unknown NAND 5 12MiB 3,3V 8-bit)
[ 0.508000] brcmnand brcmnand.0: 512MiB total, 128KiB blocks, 2KiB pages, 16B OOB, 8-bit, BCH-4
[ 0.508000]
[ 0.510000] Bad block table found at page 262080, version 0x01
[ 0.511000] Bad block table found at page 262016, version 0x01
[ 0.512000] nand_read_bbt: bad block at 0x0000059e0000
[ 0.513000] nand_read_bbt: bad block at 0x0000093e0000
[ 0.513000] nand_read_bbt: bad block at 0x00000b640000
[ 0.514000] nand_read_bbt: bad block at 0x00000cb80000
[ 0.514000] nand_read_bbt: bad block at 0x00000f5a0000
[ 0.515000] nand_read_bbt: bad block at 0x000011660000
[ 0.516000] nand_read_bbt: bad block at 0x000014020000
[ 0.516000] nand_read_bbt: bad block at 0x000018620000
[ 0.517000] nand_read_bbt: bad block at 0x00001d500000
[ 0.518000] nand_read_bbt: bad block at 0x00001eca0000
[ 0.519000] Creating 3 MTD partitions on "brcmnand.0":
[ 0.520000] 0x000000000000-0x00001f500000 : "rootfs"
[ 0.522000] 0x000000000000-0x000020000000 : "entire_device"
[ 0.524000] 0x00001f500000-0x00001fa00000 : "kernel"
[ 0.525000] EBI CS0: setting up SPI flash
[ 0.526000] spi_brcmstb spi_brcmstb.0: 1-lane output, 3-byte address
[ 0.526000] spi_brcmstb spi_brcmstb.0: master is unqueued, this is deprecated
[ 0.527000] m25p80 spi0.0: found mx25l12805d, expected w25q128bv
[ 0.528000] m25p80 spi0.0: mx25l12805d (16384 Kbytes)
[ 0.530000] UBI: attaching mtd0 to ubi0
[ 0.531000] UBI: physical eraseblock size: 131072 bytes (128 KiB)
[ 0.531000] UBI: logical eraseblock size: 126976 bytes
[ 0.532000] UBI: smallest flash I/O unit: 2048
[ 0.533000] UBI: VID header offset: 2048 (aligned 2048)
[ 0.533000] UBI: data offset: 4096
[ 3.668000] UBI: max. sequence number: 8160
[ 3.684000] UBI: attached mtd0 to ubi0
[ 3.684000] UBI: MTD device name: "rootfs"
[ 3.685000] UBI: MTD device size: 501 MiB
[ 3.685000] UBI: number of good PEBs: 3998
[ 3.686000] UBI: number of bad PEBs: 10
[ 3.687000] UBI: number of corrupted PEBs: 0
[ 3.687000] UBI: max. allowed volumes: 128
[ 3.688000] UBI: wear-leveling threshold: 4096
[ 3.688000] UBI: number of internal volumes: 1
[ 3.689000] UBI: number of user volumes: 1
[ 3.689000] UBI: available PEBs: 0
[ 3.690000] UBI: total number of reserved PEBs: 3998
[ 3.690000] UBI: number of PEBs reserved for bad PEB handling: 39
[ 3.691000] UBI: max/mean erase counter: 5/2
[ 3.692000] UBI: image sequence number: 1181977417
[ 3.692000] UBI: background thread "ubi_bgt0d" started, PID 54
[ 3.694000] ALSA device list:
[ 3.694000] No soundcards found.
[ 3.746000] UBIFS: recovery needed
[ 3.881000] UBIFS: recovery completed
[ 3.882000] UBIFS: mounted UBI device 0, volume 0, name "dreambox-rootfs"
[ 3.882000] UBIFS: file system size: 500793344 bytes (489056 KiB, 477 MiB, 3944 LEBs)
[ 3.883000] UBIFS: journal size: 9023488 bytes (8812 KiB, 8 MiB, 72 LEB s)
[ 3.884000] UBIFS: media format: w4/r0 (latest is w4/r0)
[ 3.885000] UBIFS: default compressor: lzo
[ 3.885000] UBIFS: reserved for root: 0 bytes (0 KiB)
[ 3.888000] VFS: Mounted root (ubifs filesystem) on device 0:12.
[ 3.890000] devtmpfs: mounted
[ 3.912000] Kernel panic - not syncing: No init found. Try passing init= opt ion to kernel. See Linux Documentation/init.txt for guidance.
[ 3.913000] Rebooting in 180 seconds..
Lesezeichen